I'm trying to silently install the Sharp Touch Pen Utility available
from
http://www.sharp.co.uk/cps/rde/xbcr/...ty-2.1.2.3.zip
but I'm having problems

When unzipped this is an InstallShield setup which installs some
software and then several drivers. The drivers are signed by Sharp but
no matter what I do I can't get them to automatically install without
prompting the user (as shown at
http://www.migee.com/2010/09/24/solu...omment-page-1/)

I've followed the advice on that page, I've used bcdedit to
DDISABLE_INTEGRITY_CHECKS and enable TESTSIGNING. I've rebooted and
verified that checks are disabled and that I am in "Test Mode" and I'm
still asked if I want to install the device software

In fact - If I run the install manually and tick the box that says
"Always trust software from Sharp Corporation" I am still prompted for
each and every driver

I realise that this isn't a bundle question per se but I could really do
with some help resolving this so that I can use ZENworks to push this
out to my 100+ users who are waiting for it

Thanks

Paul