On 5/17/2018 5:44 PM, jburns80 wrote:
> Correct OSP is only installed on the SSPR box. I was told this
> configuration should work by MicroFocus

Agreed. So the OSP side configuration in terms of where OAuth is running
is consistent.

So my initial concern is lessened.

What I would do next is get a tool like SAML Tracer (I like it better
than Fiddler, tomato/potato) and connect to the working node. Look at
the steps, save maybe (not sure if you can 'reload') but at least
snapshot the steps (forwards/302's/etc) that happen.

Then do the same against the bad node.

Look for differences.